A heat pump moves heat between outdoor air and the building. In heating mode it can deliver more useful heat than the electrical energy it consumes, which is why efficiency is expressed as a ratio rather than a simple resistance equivalent. That ratio changes with outdoor temperature, indoor temperature and defrost cycles.
The balance point is the outdoor condition where heat-pump capacity equals the building's heat loss at the chosen indoor setpoint. Below it, some form of supplementary heat keeps the house warm. A system designed around an average winter temperature may disappoint in a cold snap even though the equipment ran efficiently for most of the season.
Sizing should follow a room-by-room load calculation. Oversizing can produce short cycling, uneven airflow and humidity control complaints in summer. Undersizing can lead to excessive backup use. Duct design, refrigerant line length, defrost drainage and outdoor clearances influence performance just as much as the compressor specification.
The best quote includes a capacity table at local design conditions, expected auxiliary heat use and a plan for wind, snow and drainage around the outdoor unit. Controls should be configured so the thermostat does not artificially turn the heat pump into a resistance heater during modest setbacks. The owner should understand what the equipment will do when temperature drops.
Modern heat pumps work in many climates, but no product category guarantees a good installation. A complete design ties the building enclosure, load, equipment and controls together. The brand is one variable. The balance point and commissioning record are the evidence that the system was matched to the house.