Ductwork is the road system between the air handler and the rooms. A leak in a supply trunk, return chase or plenum changes more than energy use. It can depressurize a room, pull outdoor air into the building or create a pressure difference strong enough to interfere with combustion appliances. The consequences are building science, not just comfort.

Original diagram tracing return air, filtration, coils, supply ducts and room registers.

Visible tape is not proof that a joint is sealed. Traditional cloth or paper tape often fails on metal and flex joints; compatible mastic or approved tape is more durable when applied to clean surfaces. Connections need mechanical support as well as a seal. Ducts should not be crushed against joists, torn at sharp bends or left disconnected inside a ceiling.

Insulation belongs outside the sealed duct, not on the inside, unless the product is specifically designed otherwise. In an attic or vented crawlspace, uninsulated ductwork loses capacity to the surrounding air before the conditioned air reaches a register. The system then runs longer and may create hot rooms at the far end.

Static pressure and room-level airflow are useful commissioning measurements. A system can have a large nominal capacity and still deliver uneven comfort because returns are undersized, registers are throttled or the blower pushes against a restrictive filter. Correcting the distribution path often improves comfort without replacing the outdoor unit.

Before and after any duct project, document the sealed joints, insulation, supported sections and measured pressure or airflow. A smoke test or pressure test can reveal hidden leaks. The goal is a balanced network that moves the intended amount of air quietly. Duct work is mostly hidden, which makes written verification especially important.