Backup power sizing begins with a circuit-by-circuit inventory. For each device, record running watts, expected hours per day and whether it starts a motor. Refrigeration, well pumps and compressors can draw a surge far above their running load, so the battery and inverter must be checked against both continuous and peak conditions.

Original editorial diagram comparing solar production, household demand and battery backup.

Convert daily energy into a practical target. A simple estimate multiplies watts by hours, then divides by inverter efficiency and usable battery capacity. The method is intentionally conservative because cold temperatures, aging cells, reserved capacity and unexpected loads reduce available energy. A critical-loads panel can keep the list honest and prevent a small battery from being asked to carry the entire house.

Duration should be stated as a scenario. Six hours of lights and communications is not the same as twenty-four hours of refrigeration and heating controls. The owner should decide which circuits are essential, which can wait and how the system will be recharged. Solar can help during a sunny outage, but it should not be assumed to restore full service in every weather condition.

Electricians need to evaluate breaker capacity, grounding, transfer equipment and ventilation. Portable generators and batteries have different risks and operating rules. A qualified installation should make it impossible to backfeed the utility accidentally and should label every backed-up circuit. The simplest battery is not automatically the safest or most useful.

The final design should be documented with a load table, runtime assumptions and operating instructions. Test the transfer once under controlled conditions and label what will turn off. Backup power is a hierarchy of needs, and a clear hierarchy produces a smaller, better-matched system than a promise that every appliance will behave exactly as it does on the grid.